Complete system integrity: Ensure the full integrity and longevity of the Newton CDM waterproofing system with expertly designed, compatible accessories.

  • Faster, simpler installation: Speed up installation time and increase accuracy with ready-to-use, task-specific components for every common on-site scenario.

  • Effective moisture protection: Protect internal finishes and structural elements by addressing condensation and detailing challenges before they become issues.

Ancillary Products for Use with the Newton CDM System – a selection of specialist ancillary products that are critically important for the correct installation of our cavity drain waterproofing membranes.

Back-Box Liners
Pre-formed to receive electrical pattress boxes, joists, beams and pipes

Membrane: CDM 508 Mesh
Fixing Plug: CDM Multiplug
Jointing Tape: Mesh Tape
Repairs: Mesh Tape

Membrane: CDM 503 Mesh
Fixing Plug: CDM Multiplug
Jointing Tape: Mesh Tape
Repairs: Mesh Tape

Membrane: CDM 508
Fixing Plug: CDM Multiplug
Jointing Tape: CDM Tape
Repairs: CDM OverTape

Membrane: CDM 503
Fixing Plug: CDM Multiplug
Jointing Tape: CDM Overtape
Repairs: CDM Overtape

Membrane: CDM 520 eco Floor
Fixing Plug: N/A
Jointing Tape: CDM Tape
Repairs: CDM OverTape

Typical Applications

  • CDM MultiPlug (A1) – For securing Newton System 500 membranes to the wall and for providing a fixing point for 5mm screws and the CDM Helical MultiPlug Tie

  • CDM NuSeal Plugs (A2) – For fixing the membrane to vaulted ceilings and sloping soffits

  • CDM Brick Plugs (A3) – For securing Newton CDM Membranes to brickwork and concrete

  • CDM Helical MultiPlug Ties (WT 155 to 325) – For fixing into the head of the CDM MultiPlugs for the tying in of block or brick internal walls that are built in front of the Newton CDM System

  • Insulation Fixing Plugs (IF90) – For fixing CDM Fibran XPS-500C insulation spacer to the slab/raft where lightweight floor finishes are to be used

  • CDM Tape (A5, A5W) – Double-sided butyl sealing tape used to seal adjacent sheets of Newton membranes

  • CDM OverTape (A7, A8, A9) – Single-sided butyl tape used to seal the Newton PAC-500 Radon System and around protrusions at 3D detailing

  • CDM Rope (A6, A6w) – Butyl bead for sealing the base of the CDM NuSeal Plugs for fixing to vaults and soffits

  • Mesh Tape (A25) – A meshed variant of the CDM OverTape for Newton meshed membranes

  • CDM Condensation Strip (M14 & M14/500) – For collecting condensation into the CDM BaseDrain and not on internal finishes, available in 250mm x 20m & 500mm x 20m

  • Pipe Collar (A35) – Preformed pipe seal for sealing a flat membrane to a protruding pipe

  • Newtonite Pipe Sleeve (BX3) – Preformed waterproof sleeve for 110mm pipe

  • Newtonite Joist Liner (BX4) – Waterproof lining for steels and joist ends, size: made to order